FDMsrc:3DPrinting.com

QIDI's Q3D is a dual-nozzle printer with a 70°C heated chamber, and pre-orders are open

QIDI launched the Q3D at Formnext: two hotends, a 350°C main nozzle and an actively heated 70°C chamber for engineering filaments. Pre-orders are open; price is TBA.

author: EpicSlicer Editorial Teamfiled:
An enclosed 3D printer with two hotends printing a dark engineering part inside a warm, glowing chamber

QIDI used Formnext to launch the Q3D, a dual-nozzle FDM printer built for the filaments that warp and crack in an open-air room. Pre-orders are open in QIDI’s official store. The price isn’t public yet.

The specs that matter

  • Two hotends: separate nozzles, so a second material or a breakaway support doesn’t need a filament swap.
  • Main hotend up to 350°C: quick-release, and hot enough for PA, PC and carbon-fiber blends.
  • Heated chamber up to 70°C: an active heater, not just an enclosure that warms up from the bed. This is the spec that keeps nylon and polycarbonate parts flat.
  • Eddy current bed sensing and linear rails.
  • Three-stage filter: G3 pre-filter, H12 HEPA and activated carbon.

QIDI’s claims, not ours

QIDI says the extruder’s active cooling cuts heat-related clog risk by up to 90%, and that the filter catches 99.5% of airborne particles. Neither number has been tested independently yet.

Who it’s for

If you print functional parts in engineering filaments, an actively heated 70°C chamber is the spec to look for, and QIDI usually undercuts the big names on price. If you mostly print PLA in color, a multi-color system will serve you better. We’ll judge it on price once QIDI posts one.

QIDI is at Formnext hall 12.1, booth E01, through Nov 20.

#qidi#formnext#dual-nozzle#engineering-filament